Air Conditioning Parts

Image : http://www.flickr.com

The three most important parts of an air conditioning unit is the compressor, condenser and evaporator. The compressor and condenser are on the outside of the air conditioner and the evaporator is located inside.

The basic operation of the air conditioning is on the principle of successive heating and cooling based on a highly volatile liquid, eg, a freon. The liquid enters the first compressor, where it is compressed into a gas. This heat press, making theRefrigerant. The waste heat is radiated outwards with the help of a ventilator. The liquid then enters the condenser where it absorbs heat from a conversion to gas. Therefore, the surroundings are cool. The entire process is continued cyclically and that causes the cooling of the room.

Besides the three main parts of air conditioning, air conditioning also has a battery hot on the outside to dissipate heat, cold on the inside of a coil to absorb heat, the two lovers (one outsideand one internal) and a control circuit to change the temperature. This is done by changing the fan speed via a potentiometer.

The most important and expensive is the air conditioning compressor. Companies offer guarantees on the compressor and a compressor capable of providing good quality effective long worked for several years. New compressors can be purchased and in the air when the fault develops initial installed. It is ideal for a compressor from yousame company as the rest of the air conditioning. However, it is also necessary to remember that only a few companies manufacture their own compressors, the rest just buy and install in their units.

Evaporators and condensers can also be replaced. The case also applies to the cooling and heating coils. Problems in the clutches of bad heat dissipation, making the results unsatisfactory. Fans are the simpler components to replace the air conditioning units. They areSimply furnished with screws to the outside of air conditioning and with the wires to the board of air.

Another component of the air conditioning is the outer shell. The lid has no other function than to give an appearance that the air conditioning. It is usually made of molded plastic and is available in a variety of colors and designs. The same can be said of keys and buttons. Water management is essential if the air conditioning of faces in the streetoutside.

Ashtray cell phone case Desktops